transf-min updates

[mjc2wsl.git] / docs / install-fermat-on-linux.txt

diff --git a/docs/install-fermat-on-linux.txt b/docs/install-fermat-on-linux.txt
index 2503622..7f0bf46 100644 (file)
--- a/docs/install-fermat-on-linux.txt
+++ b/docs/install-fermat-on-linux.txt
@@ -5,7 +5,7 @@ How to install and use FermaT on a Linux machine
 These instructions should work on most distributions from the Debian family
 (Ubuntu, Mint, CrunchBang, ...) and with small changes on any other Linux or
 BSD system.  The main changes are in the usage of the package system -
 These instructions should work on most distributions from the Debian family
 (Ubuntu, Mint, CrunchBang, ...) and with small changes on any other Linux or
 BSD system.  The main changes are in the usage of the package system -

-debian uses ".deb" packages and the "apt-get" command, others use yum,
+Debian uses ".deb" packages and the "apt-get" command, others use yum,

 packman etc.
 
 The machine that these instructions were tested with was a fresh Ubuntu
 packman etc.
 
 The machine that these instructions were tested with was a fresh Ubuntu


@@ -49,7 +49,7 @@ Perl is included by default, but you also need some extra modules -
 Bit::Vector and Set::IntRange.
 
 If these modules are not installed WSL will work in most cases, but
 Bit::Vector and Set::IntRange.
 
 If these modules are not installed WSL will work in most cases, but

-not all. To be sure everything is ok run "make test" and check that
+not all. To be sure everything is OK run "make test" and check that

 all the tests succeeded.
 
 Debian:
 all the tests succeeded.
 
 Debian:


@@ -113,7 +113,7 @@ If you use csh or tcsh then:
   cd fermat3
   source DOIT.csh
 
   cd fermat3
   source DOIT.csh
 

-After setting the envirotment variable and path, you can recompile FermaT
+After setting the environment variable and path, you can recompile FermaT

 with the command:
 
   make-fermat
 with the command:
 
   make-fermat


@@ -126,7 +126,7 @@ and test some transformations with:
 
   test-trans
 
 
   test-trans
 

-If everything is ok you should be able to enter "wsl" in the command
+If everything is OK you should be able to enter "wsl" in the command

 line and get a usage message.
 
 
 line and get a usage message.